super blackhawk cylinder pin slipping

glockorama · December 9, 2000, 11:02 PM

I just bought a Ruger Super Blackhawk in 44 mag. When shooting the cylinder pin sometimes moves foward during recoil and locks up the action (until I push it back). Is there a way to stop this from happening? Does anyone make a more firm or sturdy cylinder pin release button?

Bob C · December 9, 2000, 11:18 PM

Make sure the pin is fully seated before firing the gun; this isn't the no-brainer it might seem. If it still slips out, try:

http://www.beltmountain.com/

George Stringer · December 10, 2000, 08:51 AM

Glockorama, you could certainly replace the pin with an aftermarket pin. But I would send it back to Ruger and make them take care of it. This should not happen. It's a quality control problem. George

December 9, 2000, 11:02 PM	#1
glockorama Senior Member Join Date: March 28, 1999 Location: WA Posts: 515	I just bought a Ruger Super Blackhawk in 44 mag. When shooting the cylinder pin sometimes moves foward during recoil and locks up the action (until I push it back). Is there a way to stop this from happening? Does anyone make a more firm or sturdy cylinder pin release button?

December 9, 2000, 11:18 PM	#2
Bob C Senior Member Join Date: January 1, 1999 Location: St. Louis, MO suburbs Posts: 386	Make sure the pin is fully seated before firing the gun; this isn't the no-brainer it might seem. If it still slips out, try: http://www.beltmountain.com/

December 10, 2000, 08:51 AM	#3
George Stringer Staff Alumnus Join Date: October 12, 1998 Location: Earlington KY Posts: 2,299	Glockorama, you could certainly replace the pin with an aftermarket pin. But I would send it back to Ruger and make them take care of it. This should not happen. It's a quality control problem. George