Pro-Shot cleaning roads?

nodule · September 12, 2011, 09:14 AM

Hi,

I just purchased the universal Pro-shot cleaning kit with the coated rods and
the red handle. Does the handle supposed to spin freely from the rod??

Tuzo · September 12, 2011, 10:24 AM

The handle of a cleaning rod spins in order to follow the twist of the bore. If your handle spins "from" the rod does that mean it spins off the rod? If so, that is a little problem. The handle rides on a bearing and should spin freely.

nodule · September 12, 2011, 10:29 AM

Thanks.

No the handle doesnt spin off the rod, it just spins freely.

nodule · September 12, 2011, 11:01 AM

Tuzo,

But when cleaning the chambers of the cylinder, I would need a fixed
handle cleaning rod, that does not rotate, correct?

Tuzo · September 12, 2011, 07:44 PM

A chamber brush has no grooves to follow because it does not go past the chamber. It merely goes into the chamber and then out; therefore, it does not matter whether the handle rotates or not.

September 12, 2011, 09:14 AM	#1
nodule Senior Member Join Date: March 7, 2011 Location: Mercer County NJ Posts: 230	Pro-Shot cleaning roads? Hi, I just purchased the universal Pro-shot cleaning kit with the coated rods and the red handle. Does the handle supposed to spin freely from the rod??

September 12, 2011, 10:29 AM	#3
nodule Senior Member Join Date: March 7, 2011 Location: Mercer County NJ Posts: 230	ok Thanks. No the handle doesnt spin off the rod, it just spins freely.

September 12, 2011, 11:01 AM	#4
nodule Senior Member Join Date: March 7, 2011 Location: Mercer County NJ Posts: 230	ok Tuzo, But when cleaning the chambers of the cylinder, I would need a fixed handle cleaning rod, that does not rotate, correct?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

September 12, 2011, 10:24 AM	#2
Tuzo Senior Member Join Date: June 14, 2007 Location: Louisiana Posts: 776	The handle of a cleaning rod spins in order to follow the twist of the bore. If your handle spins "from" the rod does that mean it spins off the rod? If so, that is a little problem. The handle rides on a bearing and should spin freely.

September 12, 2011, 07:44 PM	#5
Tuzo Senior Member Join Date: June 14, 2007 Location: Louisiana Posts: 776	A chamber brush has no grooves to follow because it does not go past the chamber. It merely goes into the chamber and then out; therefore, it does not matter whether the handle rotates or not.