Mod. 1900 H&R Ejector

Double J · April 10, 2007, 12:23 PM

I'm in the process of finishing up a rebuild of an old Mod.1900 H&R. It is a large frame, 12 ga. All I need is the ejector. Numrich didn't have that part. Before I turn one on the lathe, I'd like to try finding one. Any ideas?

James K · April 10, 2007, 05:29 PM

Start turning. If Numrich doesn't have it, most likely no one does.

Tip. You might save work by using a plain rod and welding or swaging the ejector lip onto it.

Jim

Double J · April 10, 2007, 10:31 PM

After a break, I went back out and turned one out. Round shaft .215" with an end that's .460". Pretty much got it finished except to cut the slot for the retainer pin. Sometimes there's just no easy way.

April 10, 2007, 12:23 PM	#1
Double J Senior Member Join Date: February 12, 2007 Location: So. Illinois Posts: 547	Mod. 1900 H&R Ejector I'm in the process of finishing up a rebuild of an old Mod.1900 H&R. It is a large frame, 12 ga. All I need is the ejector. Numrich didn't have that part. Before I turn one on the lathe, I'd like to try finding one. Any ideas?

April 10, 2007, 05:29 PM	#2
James K Member In Memoriam Join Date: March 17, 1999 Posts: 24,383	Start turning. If Numrich doesn't have it, most likely no one does. Tip. You might save work by using a plain rod and welding or swaging the ejector lip onto it. Jim

April 10, 2007, 10:31 PM	#3
Double J Senior Member Join Date: February 12, 2007 Location: So. Illinois Posts: 547	After a break, I went back out and turned one out. Round shaft .215" with an end that's .460". Pretty much got it finished except to cut the slot for the retainer pin. Sometimes there's just no easy way.