RCBS Lock-Out Die on Turret press

Racingsnake · September 14, 2011, 01:55 PM

Has anybody tried using the RCBS (or similar) lock-out die on a Lee 4-hole turret? I prepare my brass and priming in batches so thinking of using the spare hole for a powder checker / "powder cop".

I'd appreciate any advice you may have.

Regards, Racingsnake

higgite · September 14, 2011, 02:23 PM

Yes, I have. Same die, same press. It works fine, but I quit using it on the Lee turret because it's so easy to do an eyeball check on powder level on that press. I have started using it again, but now on a RCBS progressive press.

September 14, 2011, 01:55 PM	#1
Racingsnake Senior Member Join Date: November 5, 2008 Posts: 153	RCBS Lock-Out Die on Turret press Has anybody tried using the RCBS (or similar) lock-out die on a Lee 4-hole turret? I prepare my brass and priming in batches so thinking of using the spare hole for a powder checker / "powder cop". I'd appreciate any advice you may have. Regards, Racingsnake Last edited by Racingsnake; September 14, 2011 at 02:12 PM.

September 14, 2011, 02:23 PM	#2
higgite Senior Member Join Date: October 21, 2010 Posts: 1,028	Yes, I have. Same die, same press. It works fine, but I quit using it on the Lee turret because it's so easy to do an eyeball check on powder level on that press. I have started using it again, but now on a RCBS progressive press.