FS - Redding Competition Die Set

AVirginian · March 13, 2017, 06:29 AM

Very lightly used. I am just going a different direction.

Competition Bushing Neck Sizing Die Set #58155

These are as good as it gets.

Bushings are not included.

$230 Shipped or you can make me a reasonable offer. Anything under $200 is not reasonable.

PM me if you need more info.

IMG_20170312_080511743aa.jpg

IMG_20170312_080613511a.jpg

cw308 · March 13, 2017, 04:46 PM

I tried the Redding S type bushing dies , full & neck. From all my testing went back to the Standard RCBS Full size die with minimum case headspace gives me .001 run-out. My run-out was much higher with bushing die , depending on the brass .002-3 neck tension with standard die. That standard die gives me accurate rounds.

AVirginian · March 13, 2017, 06:24 PM

These are NOT the Type S but the full competition set. They are different and size the neck while fully supporting the case in an exactly sized sleeve that the Type S doesn't have.

March 13, 2017, 06:29 AM	#1
AVirginian Senior Member Join Date: February 6, 2014 Posts: 128	For Sale - Redding Competition Die Set Very lightly used. I am just going a different direction. Competition Bushing Neck Sizing Die Set #58155 These are as good as it gets. Bushings are not included. $230 Shipped or you can make me a reasonable offer. Anything under $200 is not reasonable. PM me if you need more info. IMG_20170312_080511743aa.jpg IMG_20170312_080613511a.jpg Last edited by AVirginian; March 14, 2017 at 12:43 PM.

March 13, 2017, 06:24 PM	#3
AVirginian Senior Member Join Date: February 6, 2014 Posts: 128	These are NOT the Type S but the full competition set. They are different and size the neck while fully supporting the case in an exactly sized sleeve that the Type S doesn't have. Last edited by AVirginian; March 13, 2017 at 08:29 PM.

March 13, 2017, 04:46 PM	#2
cw308 Senior Member Join Date: September 2, 2010 Location: Plainview , Long Island NY Posts: 3,863	I tried the Redding S type bushing dies , full & neck. From all my testing went back to the Standard RCBS Full size die with minimum case headspace gives me .001 run-out. My run-out was much higher with bushing die , depending on the brass .002-3 neck tension with standard die. That standard die gives me accurate rounds.