spiram bore brushed ?

rebs · October 9, 2016, 02:03 PM

Are any of you guys using these ? Are they any better than a regular brass brush ?

Model12Win · October 9, 2016, 11:49 PM

Boy u talkin' bout nem 'ternader brushes? Them steel jobs that twist round n' round?

Jim Watson · October 10, 2016, 08:50 AM

If'n he is, they are good in a shotgun.
A .410 Tornado will clean out a .38 revolver cylinder real well, I use one between match stages.
Worthless in a rifled barrel.

Pahoo · October 10, 2016, 11:30 AM

Quote:

Boy u talkin' bout nem 'ternader brushes? Them steel jobs that twist round n' round?

That is what I'm thinking and whenever I run into a tough bore to clean, I use one of my "Tornadoes". Have to admit that I was skeptical when I first started using them but no more. I had one bore that I had limited success with a bronze brush and two swipes of the tornado, left a mirror smooth bore. Not only that, but solvents will not eat them up, like the brass/bronze. ...

Be Safe !!!

hammer58 · October 10, 2016, 09:00 PM

Are y'all talkin about these? Will they do a good job in a very stubborn Ruger Stainless .357?

October 9, 2016, 02:03 PM	#1
rebs Senior Member Join Date: January 10, 2012 Posts: 3,881	spiram bore brushed ? Are any of you guys using these ? Are they any better than a regular brass brush ?

October 9, 2016, 11:49 PM	#2
Model12Win Junior member Join Date: October 20, 2012 Posts: 5,854	Boy u talkin' bout nem 'ternader brushes? Them steel jobs that twist round n' round?

October 10, 2016, 08:50 AM	#3
Jim Watson Senior Member Join Date: October 25, 2001 Location: Alabama Posts: 18,545	If'n he is, they are good in a shotgun. A .410 Tornado will clean out a .38 revolver cylinder real well, I use one between match stages. Worthless in a rifled barrel.