June 6, 2016, 04:38 PM | #1 |
Staff
Join Date: November 2, 1998
Location: Colorado
Posts: 21,843
|
H&R Topper
Ordered a barrel catch from NumNuts and it doesn't fit. Apparently there were different types of Toppers. The one i need is closer to the image on page 391 than the one I ordered (page 394).
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe! |
June 6, 2016, 05:41 PM | #2 |
Senior Member
Join Date: April 8, 2009
Location: Batchelor, La.
Posts: 579
|
While I go check the printed page, why do you need a barrel catch? They almost never need replacement unless they break. GW
Well, my catalog is old and out of date. You'll need to know the model # designation, 48, 158, etc. There's a bunch of them. Also if yours happens to have a transfer bar that takes one kind, the earlier H&R's used another. Last edited by Goatwhiskers; June 6, 2016 at 05:58 PM. |
June 6, 2016, 06:16 PM | #3 |
Moderator Emeritus
Join Date: April 27, 2013
Location: Ohio
Posts: 1,923
|
Gary, give them a call, and ask if they'll give you credit on the correct part, if you send that one back. I would say they will, since you didn't use the part.
You have to watch on all H&R guns, as they had design changes in all their firearms over time, even though they looked the same externally. I've not paid much attention to them lately, since Remington bought them. I imagine that they also added their own touch on a lot of the parts since then. |
|
|