April 30, 2022, 07:32 PM | #1 |
Senior Member
Join Date: June 27, 2005
Posts: 168
|
Stuck 627 cylinder
Cylinder will not budge, took off face plate, bolt moves freely. Problem appears to be inside the cylinder. How do I get at this? I’ve added oil and wiggled and wiggled and wiggled. Your thoughts pls
|
April 30, 2022, 09:38 PM | #2 |
Senior Member
Join Date: February 19, 2011
Location: Virginia
Posts: 373
|
Check to make sure the extractor rod hasn't come unscrewed.If it has tighten it up and cylinder should release.
|
April 30, 2022, 10:41 PM | #3 |
Senior Member
Join Date: June 20, 2006
Location: Surprise, Az.
Posts: 766
|
Check to see if you had a squib. If so use a range rod of brass to gently hammer it back in.
Do not use a wooden dowel. I've see too many break and you risk getting a very large splinter in your arm. Also, get a rubber mallet and tap the cylinder. This should get it out. |
May 1, 2022, 05:53 AM | #4 |
Senior Member
Join Date: February 28, 2011
Posts: 219
|
Extractor rod
FYI the extractor rod is a left hand thread....
|
May 1, 2022, 12:10 PM | #5 |
Senior Member
Join Date: June 27, 2005
Posts: 168
|
Thank you for the guidance. The extractor had backed out.
|
May 1, 2022, 12:38 PM | #6 |
Senior Member
Join Date: February 19, 2011
Location: Virginia
Posts: 373
|
Glad you got it figured out!
|
|
|