Swaping dies in hornady presses

Rangedog357 · December 25, 2009, 10:10 PM

I've just recently got two presses, a Hornady LNL AP and a Hornady classic. I want to swap dies from one to the other with out having to change the depth of the dies in the LNL bushing. I think I remember seeing a video on how to do this adjustment but now I cannot find it. Any ideas?

cv73 · December 25, 2009, 10:25 PM

i seen it on you tube just type in hornady LNL and you should be able to find it.if i remenber right they made a bushing to put under the die

FlyFish · December 26, 2009, 10:25 AM

I found some large washers at the hardware store that let me swap the resizing die between my LnL and my old Rockchucker without adjustment. They're not perfect, but close enough for resizing and expanding, and I end up having to adjust the seating/crimping die anyway

bsbxl · December 26, 2009, 07:01 PM

I think this is the video you are looking for:
http://ultimatereloader.com/?p=450

Best regards,

bsbxl

December 25, 2009, 10:10 PM	#1
Rangedog357 Junior Member Join Date: December 25, 2009 Posts: 1	Swaping dies in hornady presses I've just recently got two presses, a Hornady LNL AP and a Hornady classic. I want to swap dies from one to the other with out having to change the depth of the dies in the LNL bushing. I think I remember seeing a video on how to do this adjustment but now I cannot find it. Any ideas?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

December 25, 2009, 10:25 PM	#2
cv73 Junior member Join Date: July 4, 2001 Posts: 42	i seen it on you tube just type in hornady LNL and you should be able to find it.if i remenber right they made a bushing to put under the die

December 26, 2009, 10:25 AM	#3
FlyFish Senior Member Join Date: January 20, 2009 Location: Overlooking the Baker River Valley Posts: 1,693	I found some large washers at the hardware store that let me swap the resizing die between my LnL and my old Rockchucker without adjustment. They're not perfect, but close enough for resizing and expanding, and I end up having to adjust the seating/crimping die anyway

December 26, 2009, 07:01 PM	#4
bsbxl Junior Member Join Date: November 17, 2007 Location: Europe Posts: 1	I think this is the video you are looking for: http://ultimatereloader.com/?p=450 Best regards, bsbxl