The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Reply
 
Thread Tools Search this Thread
Old July 12, 2004, 02:15 PM   #1
SteveSteven
Junior Member
 
Join Date: July 12, 2004
Posts: 13
Help identifing old shotgun

I am trying to restore an old family heirloom shotgun, it has no makers name on it. The only name is "Standard" in Olde English script on the LH side, it is a single barrel break action gun probably made by Crescent or H&R or one of the early companies. It was probably made between 1900 to 1920, it has patent dates of Dec 18,91; Aug 11,96; Aug 14,00; May 27,02 . that is all of the writing on it. It has a serial number on the lug, it is about 4700 or so, don't have it here with me.

I am looking for imformation as to what was in the circular opening on the right side, about 0.80 inches in diameter, about 1/8 inch deep, with a 1/4 inch through hole into the center of the reciever centered on the .8" hole. If I can find out what was there, I can try to make it. It appears to have been a retainer for the hinge pin, since it intercepts the edge of the pin.

Can anyone help?

Just found my photobucket file only produces a very small image, go to here:
http://img78.photobucket.com/albums/.../RightSide.jpg
to get a full size picture.

Steve
Attached Images
File Type: jpg th_RightSide.jpg (2.1 KB, 27 views)
SteveSteven is offline  
Old July 14, 2004, 06:03 AM   #2
Harley Nolden
Staff In Memoriam
 
Join Date: January 8, 1999
Location: Brunswick,GA USA
Posts: 1,884
I have seen those shotguns, long time back, and as you describe, I believe it is a retainer pin. If my memory serves there is either threads near the top of the hole recess or a slot for a notch to secure the pin in place. By rotating clockwise releases the pin for removal.

HJN
Harley Nolden is offline  
Old July 14, 2004, 11:50 AM   #3
SteveSteven
Junior Member
 
Join Date: July 12, 2004
Posts: 13
Thanks, Harley for your reply. I had tried to thread the hole 1/4-28 for a plug, but there wasen't enough metal to hold the thread. I am now making a plug threaded 5/16-32, that will thread in. I think I will make a projecting thin piece to get ahold of to remove it. Your comment about a slot is interesting, I can see how that might be done also. Wish I had a photo of an origional to look at.
Steve
SteveSteven is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:00 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04333 seconds with 11 queries