|
March 17, 2023, 10:40 PM
|
#1 |
|
Junior Member
Join Date: March 17, 2023
Posts: 3
|
H&R 900
Have one which wont ignite primers most times.
Put washer under mainspring which increased trigger pull too much. Hasn't excess cylinder end play. I think a new spring would help. Anyone know of any NOS anywhere? Or have another solution? |
|
|
March 18, 2023, 08:44 AM
|
#2 |
|
Senior Member
Join Date: May 17, 2007
Posts: 459
|
|
|
|
|
March 18, 2023, 11:00 AM
|
#3 |
|
Junior Member
Join Date: March 17, 2023
Posts: 3
|
Thanx, was 1st place I'd looked.
Mine uses the other mainspring/rod assy. |
|
|
|
March 18, 2023, 10:53 PM
|
#4 |
|
Senior Member
Join Date: October 22, 2016
Posts: 3,962
|
I assume this was a used gun when you bought it. How long have you had it and was it in decent condition? Anytime a rimfire has issues with ignition I figure it's something that's been dry fired too much. Revolvers having multiple chambers shouldn't be an issue, but H&R's aren't exactly known for being made of high grade steel. Dry firing them could cause issues faster than with other well known companies.
__________________
"We always think there's gonna be more time... then it runs out."
|
|
|
|
March 18, 2023, 11:01 PM
|
#5 |
|
Junior Member
Join Date: March 17, 2023
Posts: 3
|
Yes, bought used.
Firing "pin" is on hammer, hard to see how dry firing could damage. |
|
|
 |
|
|
