Fn fal gas piston

Clem Paradise · March 16, 2020, 07:54 PM

I purchased a replacement gas piston for my FAL and it was shipped without the hardened tip that screws into the end of the piston that strikes the bolt carrier.

The replacement part is on the left, the current one is on the right.

Is this an error or is the tip a separate part?
Do I need to swap the tip from the old piston to the replacement?

pack_rat · March 16, 2020, 08:21 PM

The threaded gas piston is from the Austrian STG58.
It was made this way to hold a brush for cleaning the gas tube.
If it is straight and not undersized it should work fine.

Cheers,
p_r

Clem Paradise · March 16, 2020, 08:30 PM

Thank you.
Is the closed end gas piston original to an FAL?

pack_rat · March 16, 2020, 09:10 PM

Unless there are manufacturer markings that would be a tough call.
p_r

Clem Paradise · March 16, 2020, 10:11 PM

The solid tipped one has an M2 written in electric pencil on the shaft at the gas port end.

March 16, 2020, 08:21 PM	#2
pack_rat Senior Member Join Date: March 13, 2000 Location: AL50 Posts: 156	The threaded gas piston is from the Austrian STG58. It was made this way to hold a brush for cleaning the gas tube. If it is straight and not undersized it should work fine. Cheers, p_r

March 16, 2020, 08:30 PM	#3
Clem Paradise Junior Member Join Date: November 11, 2016 Posts: 11	Thank you. Is the closed end gas piston original to an FAL?

March 16, 2020, 09:10 PM	#4
pack_rat Senior Member Join Date: March 13, 2000 Location: AL50 Posts: 156	Unless there are manufacturer markings that would be a tough call. p_r

March 16, 2020, 10:11 PM	#5
Clem Paradise Junior Member Join Date: November 11, 2016 Posts: 11	The solid tipped one has an M2 written in electric pencil on the shaft at the gas port end.