M1A Handguard Retaining Clip Installation

Chief Paul · July 29, 1999, 08:33 PM

Other than a pair of $30 handguard clip pliers is there anyother way to get the Springfield M1A's handguard retaining clip to fit over the handguard without scratching them up?

Harley Nolden · July 29, 1999, 09:10 PM

Chief Paul:
Apply a light (thin) coat of vaseleine or other light grease, in the entire slot, then push down on the clip.

This accomplishes two things. Makes it easier to get on, and later off, and also puts a little lube under the clip, to prevent rust

HJN

[This message has been edited by Harley Nolden (edited July 29, 1999).]

Chief Paul · July 30, 1999, 01:02 AM

Thanks, I'm new to the M1A and still trying to work out all the moving parts...

James K · July 30, 1999, 12:14 PM

Harley,

Your method works sometimes, but sometimes it chops a big chunk out of the wood. I recommend buying or making the proper tool.

Jim

July 29, 1999, 08:33 PM	#1
Chief Paul Member Join Date: November 1, 1998 Location: Everett, WA Posts: 17	Other than a pair of $30 handguard clip pliers is there anyother way to get the Springfield M1A's handguard retaining clip to fit over the handguard without scratching them up?

July 29, 1999, 09:10 PM	#2
Harley Nolden Staff In Memoriam Join Date: January 8, 1999 Location: Brunswick,GA USA Posts: 1,884	Chief Paul: Apply a light (thin) coat of vaseleine or other light grease, in the entire slot, then push down on the clip. This accomplishes two things. Makes it easier to get on, and later off, and also puts a little lube under the clip, to prevent rust HJN [This message has been edited by Harley Nolden (edited July 29, 1999).]

July 30, 1999, 01:02 AM	#3
Chief Paul Member Join Date: November 1, 1998 Location: Everett, WA Posts: 17	Thanks, I'm new to the M1A and still trying to work out all the moving parts...

July 30, 1999, 12:14 PM	#4
James K Member In Memoriam Join Date: March 17, 1999 Posts: 24,383	Harley, Your method works sometimes, but sometimes it chops a big chunk out of the wood. I recommend buying or making the proper tool. Jim