What diameter countersink bit for standard sling swivel studs?

FirstFreedom · March 3, 2006, 02:16 PM

?? Thanks.

Rimrock · March 4, 2006, 01:19 AM

"Drill a countersink hole with a 7/32 bit to a depth of 1/8. Then drill in the same hole to a depth of 1/2 with a 5/32" This according to the instructions on the Uncle Mike's label.

[IMG]

[/IMG]
Sorry about the huge pic.
Hope it helps!

Rimrock

FirstFreedom · March 4, 2006, 02:29 AM

Thanks, bud. Yeah, that helps alot.

March 3, 2006, 02:16 PM	#1
FirstFreedom Junior member Join Date: May 31, 2004 Location: The Toll Road State, U.S.A. Posts: 12,451	What diameter countersink bit for standard sling swivel studs? ?? Thanks.

March 4, 2006, 01:19 AM	#2
Rimrock Junior member Join Date: February 19, 2006 Location: CA Posts: 273	"Drill a countersink hole with a 7/32 bit to a depth of 1/8. Then drill in the same hole to a depth of 1/2 with a 5/32" This according to the instructions on the Uncle Mike's label. [IMG][/IMG] Sorry about the huge pic. Hope it helps! Rimrock

March 4, 2006, 02:29 AM	#3
FirstFreedom Junior member Join Date: May 31, 2004 Location: The Toll Road State, U.S.A. Posts: 12,451	Thanks, bud. Yeah, that helps alot.