The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Reply
 
Thread Tools Search this Thread
Old October 6, 2001, 09:47 AM   #1
Sid K
Member
 
Join Date: April 14, 2000
Location: Sumrall, MS
Posts: 48
Remington 1100

Harley, I just bought a used Remington 1100 in 20 gauge and need instructions to detail strip. Can you help me?
My new emailaddress is: [email protected]
Sid K
Sid K is offline  
Old October 6, 2001, 10:01 AM   #2
johnwill
Senior Member
 
Join Date: April 6, 2000
Location: PA
Posts: 3,451
I have one of those too.

1. Lock the bolt open, and check for any rounds in the magazine while you're there.

2. Unscrew the magazine cap.

3. Remove the foreend and barrel forward to the front.

4. Remove the rubber gas seal ring to the front.

5. Remove the gas piston and the piston seal ring to the front.

6. Press the bolt latch and ease the bolt closed.

7. Push out the two large cross pins on the receiver.

8. Remove the trigger group, rotating it from the rear of the gun.

You can continue to disassemble from here, but I usually just hose it down with gun scrubber, then lub everything and reassemble.
johnwill is offline  
Old October 7, 2001, 04:32 AM   #3
Harley Nolden
Staff In Memoriam
 
Join Date: January 8, 1999
Location: Brunswick,GA USA
Posts: 1,884
sid K
I have sent, by separate email, the assem/disassem w/photos, as they say in the Artillary, "on the way, wait"

HJN
Harley Nolden is offline  
Old October 8, 2001, 12:17 PM   #4
RHC
Senior Member
 
Join Date: March 30, 2000
Posts: 678
Hey, Harley! Send them to me, too!
__________________
"...where the wind comes sweeping down the plains..."
RHC is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:12 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06378 seconds with 7 queries