The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old July 21, 2001, 08:49 AM   #1
[email protected]
Junior member
Join Date: July 14, 2001
Location: Bedford, NH
Posts: 72
Pistol Sighting In Advise Please

I sent my SIG P226 pistol slide off for nickel plating and didn't think to send the barrel so the smith could put my Trijicon sights back on sighted in right with a chamber laser boresighter. I have access to a Alpec .40 chamber laser boresighter and SIG rear sight pusher (B Square) to do the job.

I'd appreciate advice on sighting in for defensive pistol use (distance, red dot high, low or just on top of front post, etc.).

cbjessee@NH is offline  
Old July 22, 2001, 06:33 AM   #2
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
[email protected], I use a six o'clock sight picture so I would put the dot just on top of the post @ 25 yds. I've never tried a bore sighter with a pistol. If it were me I'd do my sighting in at the range. George
George Stringer is offline  
Old July 22, 2001, 11:02 AM   #3
Senior Member
Join Date: April 6, 2000
Location: PA
Posts: 3,451
I have to agree that a boresighter on a pistol isn't the best way. I have a cheap pistol rest that I use to sight in my pistols, works fine. I also get the job done once, and validate it at the same time.
johnwill is offline  
Old July 24, 2001, 12:35 AM   #4
Senior Member
Join Date: November 30, 2000
Posts: 341
I would definitely adjust the laser so that the dot sits right on top of the front sight...not a good idea to have to remember any differences between how the iron sights and the laser sight are adjusted when push comes to shove.
NO Compromise!
RiverRider is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:37 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.07233 seconds with 7 queries