The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old May 16, 2001, 07:07 AM   #1
Coop de Ville
Senior Member
Join Date: April 14, 2000
Posts: 436
Hello again.

My HP has an ambi thumb safety which I would like to convert for carry. Looks like theres a pin in the cross bar holding the port side lever on... Anyone popped this out and removed that lever?

Thanks -Coop
Coop de Ville is offline  
Old May 16, 2001, 07:36 AM   #2
4V50 Gary
Join Date: November 2, 1998
Location: Colorado
Posts: 19,393
The BHP ambi safety is a three part affair. The right thumb safety has the shaft which is inserted into the frame. The left thumb safety is slipped over and, as observed, secured with a roll pin. If you elect to remove the roll pin and the left thumb safety, you may find the safety shaft a mite bit long.
4V50 Gary is offline  
Old May 16, 2001, 08:33 AM   #3
Senior Member
Join Date: January 5, 2000
Location: Alabama
Posts: 197
Coop, if you would consider it, I'd like to buy your unaltered ambi safety or I'll purchase a new single side of your choice, factory or aftermarket, and swap you for yours. Email me off line if interested. Thanks.
BBBBill is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:16 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04513 seconds with 7 queries