The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old March 5, 2001, 11:16 PM   #1
Nevada Fitch
Senior Member
Join Date: October 21, 2000
Posts: 261
I doubt if many gunsmiths will do this in this day and time but has anyone delt with the cross bolt safety on the current leveractions made these days. I just plain hate them and I will never get used to them.I did read where Jeff Cooper wrote that somepeople are welding them in the fire position.I have also herd that someone makes a replacement part to swap out the offending part.Does anyone have any suggestions other than advice not to adress this problem due to potiential liability problems that might develope in case the gun was used in selfdefence or whatever?
Nevada Fitch is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:30 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04608 seconds with 7 queries