The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old February 10, 2001, 05:22 PM   #1
wolf 1415
Senior Member
Join Date: January 22, 2000
Posts: 170
Got the small Dillon tumbler and have going at it for 2 hours each time. Will the crap around the bottom inside ever come out? I'm using the Dillon media and polish. Thanks in advance.
"If cowardly and dishonorable men sometimes shoot unarmed men with Army pistols or guns, the evil must be prevented by the penitentiary and gallows, and not by a general deprivation of constitutional privilege." Wilson vs. State, Ark. 1878
wolf 1415 is offline  
Old February 10, 2001, 06:15 PM   #2
Senior Member
Join Date: September 13, 2000
Posts: 111
I assume you are talking about the "crap" inside the case at the bottom where the flash hole is? Don't worry about it, load 'em and shoot 'em.
Rokchukrslave is offline  
Old February 10, 2001, 06:54 PM   #3
Senior Member
Join Date: June 28, 2000
Location: WA
Posts: 292
Hence the need for primer pocket brushes. If you're talking about actually inside the case (where the powder sits), the media action doesn't really do the trick in there. Not super important. Just give the inside of the necks a couple scrubs with a neck brush and you're ready to reload.

Sub MOA is offline  
Old February 11, 2001, 10:39 PM   #4
dick w. holliday
Senior Member
Join Date: January 13, 2001
Location: NC
Posts: 589

i generally run for 1 hour or less with walnut shells with no cleaner added--all i want to do is clean them-if i was going to sell them or something a may go further but for now clean is ok--i also tumble rifle loads with lube on then just to get the lube off 10 minutes is about for me...Dick
dick w. holliday is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:46 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.08415 seconds with 7 queries