The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old April 1, 2013, 01:26 PM   #1
Senior Member
Join Date: February 1, 2009
Location: Southeast Texas
Posts: 137
9mm to .38 Super conversion

Guys, I purchased a STI Spartan III in 9mm recently. I had an idea of converting it to 3 Super so I did a lil research and come up with this blog
I haven't found the continuation yet, but decided to give the folks at Bar Sto a call to determine whether it could be done or not.
They said they could in fact turn me a non-bushing bull barrel to fit the slide.
So, I'm thinking it can be done, but had a few other questions.
I've read about possible feeding issues. Does the barrel need to be ramped?
Also, would the spring assembly from the same gun chambered in 45 be a good swap to tame the Supers' greater recoil over the 9mm?
Are there any other issues other than extractor work that might need to be addressed?
jason75979 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:24 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03550 seconds with 7 queries