The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old March 22, 2013, 01:04 PM   #1
Join Date: March 21, 2013
Posts: 46
.45 ACP Reloading Advise/Info

I'm new to the forum and fairly new to reloading and need input. I have some basic reloading supplies and have loaded several rifle cartridges. I'm going to load some .45 acp pistol rounds (mostly just target rounds) and would appreciate any input, tips, advise loading data, or what have you, that you guys could recomend.
KCRaider21 is offline  
Old March 22, 2013, 01:08 PM   #2
Senior Member
Join Date: April 3, 2012
Location: Northeast, Fl
Posts: 249
Have you read this?
dos0711 is offline  
Old March 22, 2013, 01:11 PM   #3
Senior Member
Join Date: April 12, 2010
Location: Lake Martin, AL
Posts: 2,880
Did you read the tutorial (see above - top line) on reloading 230 gr. 45 ACP rounds?

In my opinion, reloading the .45 ACP is about as easy as it gets for the reloader. This is except for the minor aggravatin of running into some brass with mixed large and small pistol primers.
lamarw is offline  
Old March 22, 2013, 06:11 PM   #4
Senior Member
Join Date: March 21, 2013
Location: Taxifornia
Posts: 4,404
Hi KCRaider21, I'm new to the forum too. But I've been loading 45ACP since 1985. I've loaded lots of recipes over the years. I've settled on just a few loadings after lots n lots of shooting. The two I use the most are: 200g Friendswood LSWC, 5.0g Win 231, CCI 500. And: 200g Speer (#4475) JSWC, 8.8g HS-6, CCI 500. Both loadings are in compliance with the Speer Loading Manual #14. Cartridge Overall Length (COL) are 1.23" for the lead; and 1.27" for the jacketed.

I use an RCBS press (I don't know the model - it was made in 1984) and dies. I also use a Lee Factory Crimp Die ("FCD"). I recently added the step of using the Lee FCD and it has worked wonders to reduce what few feeding and cycling problems I had.
Nick_C_S is offline  
Old March 22, 2013, 07:02 PM   #5
Misssissippi Dave
Senior Member
Join Date: December 5, 2009
Posts: 1,411
I have found loading Jacketed bullets is much easier to get the crimp right. Lead and Plated seem to be a little harder to get them right. Both 185 grain JHP and 230 grain FMJ work well for me using WST powder.
Misssissippi Dave is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:49 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04728 seconds with 7 queries