The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old February 16, 2013, 03:37 PM   #1
Senior Member
Join Date: August 8, 2012
Posts: 2,556
Woo hoo! Got to test out my first personal rifle loads.

Finally got to try out my first rifle rounds.


Swapped Nosler 77 grain BTHP for the Hornady 75 grain, started at the bottom loading of RL 15 for 10, then 10 of the middle loading.

Was actually VERY surprised. Sure I wasn't in the best situation for for testing. Bipod front rest, no real rear rest, 10 is a small sample size, and a red dot at 100 yards that is barely smaller than the bullseye.

But I had 1 in the 10 ring on an 8 inch shoot'n'C, about halfway in the bullseye at 100 yards with the low loading. 2 that were just about exactly bisected by the line. 2 in the 7 ring, 2 and 2 halves in the 8 ring. 1 and 4 halves in the 9 ring.

On the medium loading, 1 in the bull plus another 4 and a half in the 10 ring, 3 in the 8 ring, and only 1 in the 7 ring. That extra powder appears to have put another 5 inside the diameter of a drinking glass.
JimDandy is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:43 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05369 seconds with 7 queries