January 19, 2013, 11:57 AM | #1 |
Junior Member
Join Date: January 17, 2013
Location: St. Marys, Georgia
Posts: 3
|
Undercoverette 32, 6 shot
Hi everyone, I'm new to the site and have a question hoping one of you can help me with. I was given a Charter Arms Undercoverett 32 and I would like to dismantle and clean. The cylinder is very hard to unlock for loading and I hope cleaning will correct this problem. Where can I locate instructions for field stripping?
|
January 19, 2013, 04:47 PM | #2 |
Senior Member
Join Date: April 7, 2006
Posts: 10,979
|
Pull the end of the ejector rod, instead of using the thumb release.
Once the cylinder is open, there is a small screw in the center of the breech face. This screw should be adjusted flush with the breech. |
January 20, 2013, 11:04 AM | #3 |
Junior Member
Join Date: January 17, 2013
Location: St. Marys, Georgia
Posts: 3
|
Thanks Bill. As near as I can tell the screw is flush already. I cleaned good this morning and it is working better but not smooth. Perhaps it is the nature of this gun?
|
Thread Tools | Search this Thread |
|
|