The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old December 23, 2000, 02:29 PM   #1
Join Date: July 23, 1999
Posts: 26
I want to use some Lee dies in my Dillon 650, but they are too short---the lock ring won't lock the die in place---not enough thread above the tool head. Anyone been able to figure it out?
Trooper is offline  
Old December 23, 2000, 05:07 PM   #2
Join Date: November 23, 2000
Posts: 26
lee dies

you can use the LEE dies,BUT you must put the locking ring UNDER the tool head,just screw the ring off put the die in the tool head and the screw the ring on from the bottom.The dies lock in place just fine this way and it won't hurt anything.

jsn is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:12 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03976 seconds with 7 queries