The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old December 15, 2012, 09:08 PM   #1
Bob Wright
Senior Member
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 2,605
Husky screwdrivers........

Most gunsmith supply companies sell gunsmithing screwdrivers that are magnetic with interchangeable bits. Fine, except I find if I lay one down on my bench, screws or other small parts are dangling from the bit, or worse, just momentarily before dropping to the floor.

I've bought some Husky screwdrivers from Home Depot that I am beginning to like very much. They have interchangable bits that are held in place by a spring loaded ball detent, no magnet. And these bits are hollow ground to begin with, and are easily shaped with a Dremel toll to correct shape and width. And as an extra bonus, Chapman screwdriver bits work with these shanks.

Bob Wright
Bob Wright is offline  
Old December 16, 2012, 01:59 PM   #2
Doc Hoy
Senior Member
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 5,105

....We are on the same page.

The bits in the Husky set are about as perfect for my home gunsmithing needs as they can be.

In my humble opinion there is an awful lot of junk out there that is being foisted upon us at high prices and with claims of quality which simply is not there.

I made some handles which were more to my liking and pressed the Husky bits into the shank.

Handles are from an oak shipping pallet. Shanks are from an old crib.

These drivers stay nice and tight and are easy on the hands and on the finish of the firearm.

My reading of history convinces me that most bad government results from too much government. Thomas Jefferson
Doc Hoy is offline  
Old December 16, 2012, 06:31 PM   #3
Junior member
Join Date: February 2, 2008
Posts: 3,150
Those are very nice drivers. Good length. I have always preferred a driver with the bit held by mechanical means instead of magnets. Small screws and other parts are a pain in the butt if they become magnetized by a driver handle.
drail is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:47 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05366 seconds with 9 queries