The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old September 10, 2012, 09:55 AM   #1
Senior Member
Join Date: February 20, 2006
Location: Oklahoma
Posts: 381
Issues with a top punch

According to the 'structions, the 311 top punch is called for if sizing/lubing the 358212 pill. This is th 145/147 gr for the 9mm. The ogive is a bit different than the other RN molds like the xxx242 or the xxx311, et al. I am getting a ring impressed into the side of the bullet about halfway down the ogive of the thing. Anyone else have this issue? I thought about taking the dremel and taking the edge off the 311 punch. Any other ideas, like a punch that fit it better.
okiefarmer is offline  
Old September 10, 2012, 01:04 PM   #2
Senior Member
Join Date: October 13, 2009
Location: nw wyoming
Posts: 1,011
The Dremel usually works fine.
You can also put a dab of epoxy or jb weld in the top punch, lower it on the oiled bullet, and let it harden.
Then you have a custom fit.
reloader28 is offline  
Old September 10, 2012, 06:01 PM   #3
Senior Member
Join Date: February 20, 2006
Location: Oklahoma
Posts: 381
Thanks R28,

I had thought about the epoxy thing too, but I don't load too many of these heavy 9mm, and don't want to mess up my 311 punch. I have some other punches I made special nose patterns with, and that JB is hard to dig out. I could do the same thing here, but I'm fresh out of spare punches.

I might try knocking the edge off first. I did contact Lyman, and the asked me to send it in, and they would whittle me a new on if needed, send a few castings along. Every reference I see, it says 311 punch for this bullet, but it fo shizzle leaves a ring.
okiefarmer is offline  
Old September 11, 2012, 07:28 PM   #4
Senior Member
Join Date: August 1, 2007
Location: Tabor City , NC.
Posts: 1,970
Do the epoxy thing, it`ll be exactly fitted to your bullet.

Easy ,fast & cheap !
GP100man is offline  
Old September 12, 2012, 08:39 AM   #5
Junior member
Join Date: November 12, 2000
Location: Colorado Springs, Colorado
Posts: 9,494
If I have a ring on the boolit problem from an ill fitting top punch, I usually just use a flat point top punch. A teeny flat mark on the tip doesn't look as bad as a ring on the ojive.
Edward429451 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:31 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05285 seconds with 9 queries