The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Thread Tools Search this Thread
Old September 3, 2012, 10:00 AM   #1
Junior member
Join Date: July 24, 2011
Location: Saint Louis, Missouri
Posts: 849
VIDEO: How to Install a Full Length Magazine Tube on a Shotgun

I purchased a full length magazine tube from CarrierComp, a titanium tube, for my M4 Benelli and installed it yesterday. With the right tools, and with enough patience, doing it was quite straightforward. But you have to get over the fear that you are going to ruin your receiver when you start blasting away with the heat gun. In fact, unless/until smoke starts to come out, you have not heated it up enough.

Hope some may find this video useful if they decide to install a full length magazine tube for themselves. LINK TO VIDEO HERE.

I can't say enough good things about the quality of CarrierComp products, the fit and finish are truly superb. Great folks, Kip and Marcy, own/operate the business.
Amsdorf is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:13 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05519 seconds with 7 queries