The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting > Bullet Casting

Thread Tools Search this Thread
Old January 3, 2012, 01:10 AM   #1
Junior member
Join Date: January 1, 2007
Location: Idaho
Posts: 2,282
throat groove..yoohoo

Here's a happy ending. Bought a 452490gc Lyman mold for my newly rebarreled 45 SAA a couple of months ago. Cast some last week that miked at 450/451, slipped right thru the SAA's cylinder. A Uberti copy was a closer fit, but the groove seemed a little bigger than the throats..Anyway went out today with some loaded up with titegroup and shot up 30 or 40 rounds..not on paper but kept cans bouncing around...Checked the barrel before going to remington swaged hollow bases ( puts the crud into cruddy bullets) and the barrel was slicky clean. Now if I could find a bullet for the SAA.
salvadore is offline  
Old January 5, 2012, 06:07 PM   #2
Senior Member
Join Date: March 22, 2002
Location: In The Hardwoods
Posts: 1,108
Now if I could find a bullet for the SAA.
What are you looking for?
LAH is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:59 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03859 seconds with 7 queries