The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Thread Tools Search this Thread
Old February 23, 2011, 07:29 PM   #1
Nick S.
Senior Member
Join Date: September 4, 2010
Location: New York
Posts: 145
Old Stevens 16 ga.

I was cleaning my SXS 16 ga. as usual after returning from the trap range and while running cleaning patches through the barrels I was looking at the plastic fore grip laying on the table. I noticed a rectangular hollow at the foward most end. I always thought it was there to add lightness & save on material used. Then I thought, I wonder if a shell would fit inside it when reassembled. It fit perfectly & rattled just a little. Wraping a clean patch around it should silence the rattle. Did anyone else already know that?
Nick S. is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:12 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06266 seconds with 7 queries