The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old January 6, 2011, 10:37 PM   #1
Quick Karl
Junior member
Join Date: June 10, 2008
Location: Scottsdale, AZ
Posts: 36
Barrel Vise

I wanted a barrel vise and wasn't too happy with the prices of the vises I was able to find online so I drew one up in Solidworks. Estimated material cost is less than $50 and a local machinist will mill the slots and v-ways for cheap so I will have a 10-times sturdier vise that will hold anything from .600" diameter to 1.250"+ diameter for less than the cost of one probably made in China...

Quick Karl is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:49 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04190 seconds with 7 queries