The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Thread Tools Search this Thread
Old December 26, 2010, 12:51 PM   #1
Join Date: October 12, 2010
Location: Cortez, CO
Posts: 33
Brownells and screwdrivers

I got a hundred dollar gift certificate from Brownells. I have a Pietta 1851 Navy, 1858 Army, 1860 Army and a Walker Colt. I could use a screwdriver set for all of them. Question is which one with which bits? I read many posts on this forum and am more confused than ever. Some like the Chapman set but say the bits break easily.

Others like the Magna-tip sets but they come in so many different configurations I am not sure which one has the size of bits I would need for the above guns. Then some say the Magna-tip sets do not have the straight surface long enough at the tips and the rounded part of the grind hits the sides of some screw slots. Others like the Magna-tip thin bits, but the website shows a set of 18 and no price with the listing showing eight bits sold by the each?

Others like the brand specific Brownell's sets for the Colt and Ruger.

Any clarification that can help me decide is appreciated.

Any other items at Brownells that are useful for black powder guns and shooting in the even I have money left over to spend from the gift certificate? I need a good nipple wrench but did not find anything at the Brownells website using their search engine.

Thanks in advance for any ideas.
McPhee is offline  
Old December 26, 2010, 01:07 PM   #2
Senior Member
Join Date: June 24, 2008
Posts: 2,157
Get the biggest set you can. Sure, the smallest Chapman bits may break, but that's because they're small bits. Small bits are subject to breakage. In addition to the large set, get an inexpensive set of fixed blade screwdrivers you can grind to fit. No matter how big a set you get, eventually you will find a screw that doesn't have a match.
natman is offline  
Old December 26, 2010, 06:20 PM   #3
Senior Member
Join Date: October 8, 2006
Location: Northern Michigan
Posts: 2,772
The best single set for the replica cap and ball revolver is the Brownell's Colt SA set. It may not have a bit to perfectly fit one or two of the Italian screw slots, but should work for almost everything. I bought the 22 bit Starter Super Set, then added more bits as I needed them for guns other than the cap and ball guns. Never have had a problem with the bits fitting the slots due to the long side being rounded too far down.

I also have a Chapman set, and yes, I've broken bits on frozen screws that had to be soaked or even drilled out on guns I've restored. Breaking a Chapman bit is not necessarily a bad thing; it tells me to get out the Kroil or ATF/acetone mixture. And they're cheap.
mykeal is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:23 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05820 seconds with 7 queries