The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old December 25, 2010, 10:12 PM   #1
Senior Member
Join Date: October 5, 2007
Posts: 371
SP101 trigger problem help

I have a SP101. The gun was functioning prior to tinkering (imagine that) I took it apart to install a Wolf spring kit. I got it all put back together and it and the trigger would not pull back. I took it apart and followed the reinstallation steps as well as I could understand. It will cycle a few times then it wont then it will. I reinstalled everything without the pawl installed and it pulls fine. I am wondering if there is something simple to watch for or change. I am installing the trigger group with the transfer bar and the pawl straight up. When it does cycle its mighty smooth. I will be grateful for any help.
camsdaddy is offline  
Old December 25, 2010, 10:32 PM   #2
Join Date: February 12, 2001
Location: DFW Area
Posts: 21,131
If the trigger return spring from the spring kit you installed is too light it may not have enough oomph to fully reset the trigger each time. That will cause the trigger to appear to lock up.
Did you know that there is a TEXAS State Rifle Association?
JohnKSa is offline  
Old December 25, 2010, 10:34 PM   #3
Senior Member
Join Date: October 5, 2007
Posts: 371
I think I have found I was missing the plunger and spring that hold the pawl.
camsdaddy is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:10 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04432 seconds with 7 queries