The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old December 20, 2010, 08:55 PM   #1
Senior Member
Join Date: December 18, 2010
Location: South Central Pa
Posts: 692
D/T under side of a Cantilever?

Who knows if its best to D/T the underside of a cantilever and place a plastic screw in to keep the cantilever steady or will I achieve the same thing placing the screw in the top of the receiver going up? I just want to add a little support to the back end.
pabuckslayer08 is offline  
Old December 23, 2010, 04:34 PM   #2
Join Date: October 15, 2010
Posts: 16
Why? I Thought the purpose of a cantilever scope was too keep you scope lined up with the barrel instead of the reciever? seems like if there is any movement between your barrel and reciever the pressure on the screw is going to change a possibly change your point of aim a bit. Just doesn't seem like it would be any better than mounting the scope on the reciever. I could be wrong though, I'm no expert.
dieselguy is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:44 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04013 seconds with 7 queries