The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Thread Tools Search this Thread
Old October 5, 2010, 08:49 AM   #1
Junior Member
Join Date: September 15, 2008
Posts: 2
T/C Renegade rear sight?

Hello all,
This is my first post and hope someone help me. I have T/C Renegade and just installed a Lyman peep sight with no problems. My problem is how o I take off the original rear sight off the octagon barrel? There are only two screws I can see, one for elevation and one for windage.

Thanks for any help
speterson701 is offline  
Old October 5, 2010, 09:52 AM   #2
Senior Member
Join Date: February 16, 2006
Location: IOWA
Posts: 6,995
If it's like the others I have worked, all you have to do is remove the elevation screw all the way and your top blade will be pushed up by a spring. Carefull remove the spring and top blade. You may have to drive out a roll pin on the front pivot point. Then again, you may not. You should now see two screws that anchor the base blade, to the barrel. Remove them and there you have it. Let the project talk to you as it will tell you what it needs. Reassemble the sight so you don't loose any of the parts, like I have done in the past.
One note of caution is to be careful on reinstalling any screws as these are too darn easy to cross-thread.

Be Safe !!!

Last edited by Pahoo; October 5, 2010 at 09:58 AM.
Pahoo is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:07 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04825 seconds with 9 queries