The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old July 22, 2010, 12:05 PM   #26
Senior Member
Join Date: December 23, 2005
Location: Minnesota
Posts: 2,850
I see on the bottom of your graph "22-24.5gr" of TAC. If I run 22gr of TAC not 24.5, my QL will show the same graph as yours. Try plugging in 24.5gr and not 22-24.5 and see what pressures you get.
steve4102 is offline  
Old July 22, 2010, 12:43 PM   #27
Junior member
Join Date: March 13, 2008
Location: AZ
Posts: 1,129
I don't have the software, a friend ran that for me. But I think/hope you're right! That would take my propellant burn rate up over 91%.


I just looked at another chart that shows 22-26.3 grains, and it's showing a peak pressure of 39k??? I wonder if it's giving an Average/Median pressure??

Last edited by demigod; July 22, 2010 at 12:58 PM.
demigod is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:52 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04331 seconds with 7 queries