The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old July 1, 2010, 12:20 PM   #1
Senior Member
Join Date: February 3, 2007
Location: Far West Texas
Posts: 109
Finishing Question?

OK, so Ive got my new to me Glock 23 that I did a little frame sanding on. I tend to have a really high hold on the grip so naturally I suffer from the "Glock Knuckle" on my middle finger because of the blocky trigger guard, so I decided to carefully take a Dremel with a sanding drum to it. I now have it adjusted like I want it and was wondering if anyone knew of a good way to shine the plastic back to match or closely match the rest of the polymer factory finish. I was thinking of carefully and slowly rubbing the area with a little acetone, what do yall think. Thanks for any ideas.
Boomer8404 is offline  
Old July 1, 2010, 09:19 PM   #2
Senior Member
Join Date: May 4, 2001
Posts: 7,042
Lacquer thinner should have no effect on the type of plastic Glock uses. It's intended to be solvent proof to most common solvents.

A better option is a plastic polish. You can buy plastic polishes at automotive stores where it's sold for polishing head light covers.
Dfariswheel is offline  
Old July 2, 2010, 08:49 AM   #3
Senior Member
Join Date: August 6, 2009
Location: Albuquerque
Posts: 2,776
Solvent is one of the worst options for "shining" polymers. They either swell the material, dissolve the surface into a sticky mess, or, worst case, allow the material to crystallize. Plexiglas type polymers become hazy with a single drop of acetone. A bit of jeweler's rouge should do the trick polishing. You can try heat, but that requires practice, and a gun frame is probably not what you want to use as your first practice piece.
I used to love being able to hit hard at 1000 yards. As I get older I find hitting a mini ram at 200 yards with the 22 oddly more satisfying.
mapsjanhere is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:45 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06928 seconds with 9 queries