The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old March 16, 2010, 03:48 PM   #1
Junior Member
Join Date: March 16, 2010
Location: Alabama
Posts: 1
Glenfield 60 Misfeed

I recently picked up an abused Glenfield 60. After I broke it down and cleaned it, I took it to the range and suffered through several misfeeds. About every third round came out unfired, with the bullet bent over slightly. The action would remain open, and in cases where the shell did fire the spent casing was cleanly ejected. I took it apart again and found that the arm that raises the bullet through the feed throat was catching on the bottom edge. The riser spring is pullihg the arm slightly to toward the side the spring is mounted on, causing it to catch the underside edge of the feed throat. This seems wrong to me, but I have no history with these types of rifles. The arm only catches for a moment, then slams upward, which leads me to believe the misfeeds are being caused by the sudden upward release of tension.

Assuming I'm right, how do I go about getting the arm realigned with the slot in the feed throat? Thanks in advance for any answers.
1075Hoehn is offline  

glenfield , marlin

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:26 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.07480 seconds with 8 queries