The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting > Bullet Casting

Thread Tools Search this Thread
Old September 30, 2009, 11:48 AM   #1
Senior Member
Join Date: December 30, 2008
Location: Central Texas
Posts: 259
My first batch of cast bullets

With a lot of help from you guys on the forum, I cast my first 100 bullets this week - Lee TL356-124=2r double cavity. I've loaded up ten of them at 3.5 grains of bullseye to make sure they cycle the action of my CZ75 before I do any mass production. I did have to get the Lee double cavity very hot to produce good casts but once I got the hang of it, it seemed pretty straigtforward. I do need a little more experience to learn just the right time to cut the sprue and drop the boolits. Out of a little more than a hundred I wound up culling 7 that had the krinkled noses or poorly filled out bases. all in all, alot of fun and just thought I'd share. (see pic)
Attached Images
File Type: jpg IMG00112[1].jpg (165.0 KB, 67 views)
awaveritt is offline  
Old September 30, 2009, 12:20 PM   #2
Senior Member
Join Date: August 1, 2009
Posts: 166
very nice! careful it's adicting though lol
rbf420 is offline  
Old September 30, 2009, 12:29 PM   #3
Senior Member
Join Date: December 23, 2008
Location: Southern Illinois
Posts: 1,525
Those look mighty fine for a beginner! Great job! As far as cutting the sprue, the best time is when the sprue "frosts over". You will notice that right after you pour the lead into your mold, the puddle of lead on the sprue plate will change color/texture and go from a shiny (molten lead) look to a frosted (semi-hardened lead). When you see this change, you are OK to cut the sprue. As the mold and sprue plate gets hotter and hotter, it will take a little longer for the sprue to harden...thus you have to wait longer to cut it. What I do is I have a damp sponge on hand and when the sprue is taking too long to harden (more than 5 seconds or so) I will touch the bottom of the mold to the sponge for 2-3 seconds (with the bullets still in the mold) to take some of the heat from the mold. This helps keep the mold temperature in the "sweet spot". Keep up the great work!

BTW....try Bullplate lube on the makes casting a dream!

IllinoisCoyoteHunter is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:45 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06332 seconds with 8 queries