The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Thread Tools Search this Thread
Old April 19, 2009, 08:07 PM   #1
Senior Member
Join Date: March 24, 2009
Location: RGV, Tx
Posts: 787
yet another question about my jp sauer & son western marshal 357 magnum s/a revolver

I have found all but one part. I need a base pin for it and I was wondering if that base pin is the same size as another brand ( i.e. ruger ect.) and if they are interchangeable.
And death climbs the steps one by one, To give you the rose that's been burnt by her son, Point me to the sky above I can't get there on my own, Walk me through the graveyard Dig up her bones
Hellbilly5000 is offline  
Old April 20, 2009, 08:12 AM   #2
Senior Member
Join Date: September 19, 2008
Posts: 4,678
If you have no other cylinder pin for a trial fit, have you measured the hole diameter & depth ?

A drill bit shank might get you close enough - or carry the cylinder to gunshows and ask the parts guys for a match.
PetahW is offline  
Old April 20, 2009, 02:27 PM   #3
James K
Join Date: March 17, 1999
Posts: 24,278
A base pin is usually an easy part to make if you can't find one.

Jim K
James K is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:04 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.09331 seconds with 9 queries