The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old March 30, 2009, 07:46 PM   #1
chris in va
Senior Member
Join Date: December 26, 2004
Location: Louisville KY
Posts: 13,534
Dehorning stainless steel?

I just bought a Kahr K9 and while the gun is amazing, the grip cut the web of my hand at the range today. There's a sharp edge where it curves down to meet the rubber.

Anything I can do with a Dremel and not ruin it?

chris in va is offline  
Old March 30, 2009, 07:55 PM   #2
Senior Member
Join Date: January 18, 2005
Location: Idaho
Posts: 146
Get some 3M wet/dry sand paper (320 or 400) grit and use that.
Wrap it around a wood dowel and then go to it.
ogree is offline  
Old March 30, 2009, 08:06 PM   #3
Senior Member
Join Date: November 13, 2006
Posts: 5,306
Well,I do not see a problem with beaking the corner,especially in stainless

I suppose some folks might do a fine job with a dremel,but I think you would be more likely to mess up with a dremel.

I might use a very fine oval needle file to put a uniform .010 or so 45deg chamfer down the line.Then,to see better,you might marker it then just break the new corners,so you have somewhat made 3 flats of an octagon,on a small scale.

Then I might use about a 320 or 400 grit polishing stone,or even an india stone,to blend it to round.Use a bit of oil and a light touch,maybe follow with a little 500 then 600 wet or dry and some oil.Then,maybe a little maroon scotch brite for a brushed look.

under a finer image quality,the part looks like it has a glass bead finish.thats pratty easy.Its not the same as blasting with sand,it just frosts it.
HiBC is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 04:29 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04815 seconds with 7 queries