The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old November 18, 2008, 04:53 AM   #1
Senior Member
Join Date: February 4, 2006
Posts: 206
Mini-Mauser rebarrel

Anybody found a standard thread that will work for the mini-mauser?
I'm trying to get out of resetting my lathe to cut metric threads. It's a pain having to cut threads by starting and stopping without disengaging the half nuts.
sadsack is offline  
Old November 18, 2008, 12:58 PM   #2
Senior Member
Join Date: June 16, 2008
Location: Wyoming
Posts: 10,915
Try this
Kraig Stuart
USAMU Sniper School Oct '78
Distinguished Rifle Badge 1071
kraigwy is offline  
Old November 20, 2008, 03:02 AM   #3
Senior Member
Join Date: November 13, 2006
Posts: 5,440
Assuming you are only threading one barrel,turn off the breaker or unplug the lathe,and turn the chuck by hand,forward and reverse.use a sharp tool and light cuts. Do back out before you back up.Yeah,there are drawbacks,but it have great control over where the cut stops.Each cut,try to stop just barely shy of the previous chip so you don't snap off the tip of your cutter.Use a good lube.
HiBC is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:33 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.08020 seconds with 9 queries