The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Thread Tools Search this Thread
Old September 19, 2008, 12:18 AM   #1
Junior Member
Join Date: September 19, 2008
Posts: 1
need help for a stevens 77c shotgun

i have a stevens 77c shotgun that i took apart to clean. well, i dont know exactly how to put it together. i got it back close put the shells are not feeding. can anybody help me or send a diagram to me......thnx
protoker is offline  
Old February 10, 2009, 01:48 PM   #2
Junior Member
Join Date: February 10, 2009
Posts: 2
i think i know what is wrong, i picked up the same gun at an auction and found the same thing. mine will eject the shell from the tube but it will jam and not proceed into the chamber, i fixed it yesterday after a healthy bout of swearing, but i noticed the arm that holds the shells back in the tube has a tine little spring that allows it to fall back in place one a shell has been cycled. if you hold the gun muzzel up and look into where you load it you'll see the arm that i am talking about on the right side, you should see a little spring near the bottom of the opening holding the arm up, or the hole that it goes into. if this is missing i'm sure a local gunsmith will have something that'll work, if not i used a flint spring from a bic lighter and just cut.

hope this helps
ex-driller is offline  

assembly help , shotgun , stevens

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:39 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04213 seconds with 7 queries