|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
August 6, 2008, 01:28 PM | #1 |
Junior Member
Join Date: February 19, 2008
Posts: 2
|
Ejector Collar Rossi Model 1892 .357 Caliber
Three weeks ago I picked up a New Rossi Model 1892 caliber .357. I have not fired it yet. I jammed it when unloading 38 Special 158 grain dummy Cartridges. Two rounds got into the chamber. I turned the gun over while working the lever casing the failure to feed. I disassembled to clear the jam.
I am not a gunsmith and it took me several days to reassemble. After I’m done, I note a part like the “Ejector Collar” in my parts tray. I looked into the chamber and see a Collar on the Ejector. Is there the need for two collars when reassembled? Is a second Collar needed someplace else? After reassembly, I loaded 50 rounds and unloaded them - twice two rounds jammed. I unloaded these jams through the magazine—much simpler to reassemble. The extra “Collar’s” dimensions are: Inside Diameter .155 Outside Diameter .235 Length .171 I’d rather not disassemble to measure the Collar in the rifle. very tough to reassemble. The gun appears to be cycling OK. Later this week I’ll get a chance to fire it at a range. I'll check on how the rifle cycles. Is there a second “Collar” needed? What are the dimensions of the Model 1892’s Extractor Collar? Thanks Rollin’ Ranger |
August 10, 2008, 12:48 AM | #2 |
Member
Join Date: October 12, 2005
Location: Prescott, AZ.
Posts: 73
|
There should be only one collar on the ejector. It sounds like the extra collar was installed by someone who cut the ejector spring too short.
Also, to cure your misfeeds, make sure you are only using round nose bullets, and better yet, if you are a Cowboy Action Shooter and a handloader, load .357 cases to .38 special velocities. The shorter .38 case has a tendancy to jam when cycled rapidly under the clock. Also, on your nomenclature, the chamber is in the barrel, and you can't get two dummies into the chamber at the same time. I think you meant to say "the receiver" instead of chamber.
__________________
Gunsmith/Machinist |
August 14, 2008, 09:06 AM | #3 |
Junior Member
Join Date: February 19, 2008
Posts: 2
|
Thanks for the info -- yes I did mean the Reciever.Jrjrhare
|
|
|