Mossberg 500 trigger group...

hogdogs · July 6, 2008, 09:56 PM

Any of you guys experienced in the tear down/reassembly of the trigger group? I am proficient enough to do the work just need step by step guidline instruction and warnings to heed. If it looks to be too much for me when I read through it I will refrain. I am sure there is some sand in there as it was my dump truck back window gun and pick up gun for years...
Brent

Slopemeno · July 6, 2008, 10:40 PM

Spray some solvent in there, and blow it out with compressed air, then lube. You might even try the air alone. I found them to be a major PITA and not worth the effort to disassemble.

hogdogs · July 6, 2008, 11:56 PM

If they are a SEVERE PITA I may skip it... Heck I figure if I can do a 100% tear down/rebuild on those mini carburetors on 2 stroke equipment I could delve into this...
Brent

July 6, 2008, 09:56 PM	#1
hogdogs Staff In Memoriam Join Date: October 31, 2007 Location: Western Florida panhandle Posts: 11,069	Mossberg 500 trigger group... Any of you guys experienced in the tear down/reassembly of the trigger group? I am proficient enough to do the work just need step by step guidline instruction and warnings to heed. If it looks to be too much for me when I read through it I will refrain. I am sure there is some sand in there as it was my dump truck back window gun and pick up gun for years... Brent

July 6, 2008, 10:40 PM	#2
Slopemeno Senior Member Join Date: January 19, 2007 Posts: 2,663	Spray some solvent in there, and blow it out with compressed air, then lube. You might even try the air alone. I found them to be a major PITA and not worth the effort to disassemble.

July 6, 2008, 11:56 PM	#3
hogdogs Staff In Memoriam Join Date: October 31, 2007 Location: Western Florida panhandle Posts: 11,069	If they are a SEVERE PITA I may skip it... Heck I figure if I can do a 100% tear down/rebuild on those mini carburetors on 2 stroke equipment I could delve into this... Brent