The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Thread Tools Search this Thread
Old May 20, 2008, 12:56 PM   #1
Senior Member
Join Date: April 14, 2008
Location: Stafford, VA
Posts: 2,244
Pietta 1858 45 colt r&d conversion cylinder question

Looking into the cylinder chambers, it looks like each one is a tiny bit narrower at the barrel side, like it was bored a certain width up to the last quarter inch or so of the end of each chamber, then it is slightly narrower. Is this normal? I only noticed this the last time I cleaned it.
noelf2 is offline  
Old May 20, 2008, 04:43 PM   #2
Senior Member
Join Date: May 22, 2007
Location: In the oak studded hills near Napa
Posts: 2,203
Mine is same. It serves to neck down from the case diameter to something closer to the bullet diameter, helping to align the bullet with the forcing cone thereby aiding in accuracy.
grymster2007 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:33 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04480 seconds with 9 queries