The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Thread Tools Search this Thread
Old March 10, 2008, 08:59 PM   #1
Senior Member
Join Date: April 11, 2006
Location: Northeast Ohio
Posts: 3,403
Bullet trap plans

I'm looking for plans to make a bullet trap for my basement range, and can't find any. Something that would handle .38/9mm. I've got a .22 bullet trap, and it works fine, but I'd like to shoot the bigger iron sometimes. Yes, my air-handler has ducts in the basement and a HEPA filter, so I'm not too worried about lead.

I'm fairly handy with a table saw, drill, and router. I'm guessing (and only guessing at this point) that a 18"x18" piece if 1/4" steel and some 3/4" plywood might work.

Any advice would be greatly appreciated.
skeeter1 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:22 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03805 seconds with 7 queries