The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Thread Tools Search this Thread
Old March 7, 2007, 10:41 AM   #1
Junior Member
Join Date: February 6, 2006
Location: Montreal, Canada
Posts: 5
Enfield Revolver Disassembly?

Never mind, I got it out. I rigged up a jig in a vice and it only took a small amount of pressure to pop out.


I recently acquired an Enfield No2 MK1 revolver that needs a good cleaning. I had no problem with full disassembly, except that I can't get the hinge pin out(I think that's what it's called, the internally threaded bushing inside the hinge). It Should simply push out, but I guess after being in there for 80 years it wants to stay put. I tried penetrating oil (WD40) and gently tapping it out with a punch, but I don't want to go at it too hard.
Any tricks I should try? Putting it in the freezer maybe?
I'd like to get it out if I can. There's a whole lotta gunk in there..

Thanks, Steve

Last edited by tapedeck74; March 7, 2007 at 12:27 PM.
tapedeck74 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:20 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04022 seconds with 7 queries