The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old October 23, 2000, 09:30 PM   #1
Senior Member
Join Date: October 13, 1998
Location: Arizona.
Posts: 853
I used to buy the excellent Remington .45acp snakeshot loads, but they are no longer available.
They featured a star crimped end, and they fed and functioned very well. Much better results than the crappy CCI plastic tipped cannister stuff.
I am looking for either a source for the discontinued ammo, or dies so that I can make some myself. I presume that I will have to use some longer brass of my own manufacture, unless something already exists that I don't know about.
Suggestions, techniques, formulae, and sources welcomed.
Thank You,
Mad Dog
MAD DOG is offline  
Old October 23, 2000, 11:30 PM   #2
Join Date: October 16, 1999
Posts: 16
RCBS used to make a 45 shotshell die set. IIRC it used cut down 308 brass, and a cardboard top card. Seems like the last time I looked, Midway had them.
dving is offline  
Old October 24, 2000, 10:36 PM   #3
Senior Member
Join Date: April 2, 1999
Location: U.S.A.
Posts: 566
get the RCBS dies and ya can make blank loads
zot is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:05 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04848 seconds with 7 queries