The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old April 27, 2000, 08:30 PM   #1
Join Date: April 5, 2000
Posts: 58
Looking for info on cast bullet wadcutter target loads for the 32 s & w, for use in a hammerli.

"Our most pressing problems...are at their core moral, not material, problems." Richard Nixon
"We should not substitute the state for the parents or the family." Lee Kwan Yew
B24H is offline  
Old April 27, 2000, 08:51 PM   #2
Kenneth L. Walters
Senior Member
Join Date: September 2, 1999
Location: flagstaff, arizona
Posts: 476
Which Hammerli do you have? I'm sure that you meant S&W Long rather than the much shorter 32 S&W round. I would think that you could find a starting load in any of the Lyman handbooks and then adjust it until the gun cycled properly.
Kenneth L. Walters is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:54 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06695 seconds with 7 queries