The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old February 13, 2000, 07:22 PM   #1
Join Date: January 15, 2000
Posts: 47
Hi everyone
I cast my own 9mm and 357 now. I just got a 1991A1 COLT. I was wondering if you have tried and liked the Lee molds in 230 LRN. My 9mm are Lee and seem to work consistent. Also any load suggestions are welcome. Target shooting only with wheelweights. I prefer non gascheck design as I must admit I hate sizing and had good results just casting and Lee Liquid Alox. Thanks for any help racer
Boondocker is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 04:34 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03797 seconds with 7 queries